Probelsm with adidas x-traxion sg studs

[GunthorpeHarrier]

i recently bout balck and white f50+ sg .after just 2 training sessions and 1 match i was missing a stud in each of the inside rear. i have had metal x-trx for the whole of last season and didn't have a problem with them. Is this a manufacturing error or something i donn't know about the adidas sg that has changed since last season. i can assure you i checked if studs was intact before using. anybody else had similar probelms?

[metropolis2k]

This comes up fairly regularly on forums and it's usually because people don't check the studs are fully pushed in when they use them for the first time.

[schssoccer27]

The same exact thing happened to me with my cyber and gold f50+
wore them one match and was missing a stud

[camerony]

Is there any way to make sure they are 'properly in' before a match? I lost a front stud in my first game in my Pulses but luckily my dad got some replacements (the replacements were too small - the back replacement studs were only as big as the normal front studs!).

[metropolis2k]

Just make sure there's nothing underneath them stopping them being in place (like mud) and push them in as hard as you can (or get your dad to do it).

I notice you're in Australia - are the pitches hard? The pitches might be too hard for SG boots.

[joto 3]

ya.. hes right... if yhe pitch is too hard... it will wear the studs and you will most likely lose a few...
it happened to me

[camerony]

The pitches aren't too bad actually. To be honest I have never been overseas so I have nothing to compare it to, but I've worn the SG studs a few times and haven't had any troubles with stud pressure, etc. I live in Western Australia and the pitches are apparantly harder here than over in the Eastern States but I just got picked for the state team and the coach said we needed SG boots for when we go over there for the national championships. Most of the time I use my FG boots though.